Adjustments And Connections - HumanTechnik PRO LOOP D5 Mode D'emploi

4.5.3 Mounting the loop driver on a wall
Using the provided screws, fasten the brackets to the amplifier as shown in the picture
below. Then attach the amplifier to the according wall.
4.6 Adjustment and connection
4.6.1 Loop connection
The induction loop is connected via the »speakON« connector located on the rear panel
of the driver.
The cables connecting the actual loop and the driver must be placed close and parallel
to each other. If possible, twist them. This avoids inductive interference which may be
caused by other transformers in the vicinity.
4.6.2 Audio inputs
Audio sources connect via the 3 inputs of the amplifier provided for this purpose.
The driver has 3 types of input :
INPUT 1: Line or Micro INPUT 2: Line or Micro INPUT 3: 100 V
28 English