HumanTechnik PRO LOOP D5 Mode D'emploi page 24

4.3 Front panel and controls
2 3
1 4 5 6
1 ON / OFF power button.
2 LED »Loop OK«. This green LED is displayed when the loop is in working condition.
3 LED »Protect« error display. This red LED lights up when the driver unit for
the loop overloads or the loop is defective.
4 Power LED, ON / OFF display. This light indicates the device is on power.
5 LED »Clip« error indicator. This red LED lights up when the input level for the loop is too
high.
6 Input 1 setting (Line or microphone). This adjusts the signal level of INPUT 1.
7 Input 2 setting (Line or microphone). This adjuster is for the signal level of INPUT 2.
8 Input 3 setting (100V). This controls the level of INPUT3.
9 Metal Loss Compensation: Adjust to reduce interference with metal structures.
10 Input level indicator.
11 Loop current output adjuster. Controls the electric current in the loop.
12 Loop output indicator.
13 6.3 mm headphone jack for monitoring.
24 English
7 8 9 10 11 12 13