Mounting The Hood - Zephyr Napoli ZNA-M90DS Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Mounting the Hood

CAUTION
Hood is intended to be mounted to a finished
Ceiling Preparation
1. Determine hood mounting location and
temporarily tape paper template (included with
the hood) to the ceiling.
2. Cut-out internal shaded area of template
to allow the ducting and electrical to pass
through.
3. Add wood blocking (min. 2" x 4") onto ceiling
joists to reinforce ceiling above the drywall.
(FIG. C1).
4. Secure (2) #6 x 1" wood screws into points A
and B of the paper template (FIG. B). Do not
completely tighten screws, leave approximately
1/4" exposed.
Hood Preparation
5. Remove screws securing top and bottom
support frames together.
6. Adjust support frame to accommodate the
desired hood height and re-assemble the frame
using the previously removed screws (2 screws
for each support frame arm). (FIG. C2).
14
ceiling.
Front of Hood
B
Cut-Out Shaded Area
FIG. B
Ceiling Joists
Wood Blocking
Top Support Frame
Support Frame Arm
Bottom Support Frame
Hood Body
FIG. C
Napoli Use, Care, and Installation Guide
C O R E
N A P O L I
I S L A N D
A
XP022220
1
2
3
4
Mounting Screws
(pre-installed)