Cable Routing; Power Supply - Abus Eyseo TVCC40000 Manuel Utilisateur

6.1.4. The counter nut at the camera base will
fix the ball type ankle.
The camera's angle of view can be
adjusted like described in chapter 6.5.
Please connect power and monitor
first.

6.2 Cable routing

For cable laying there are two ways available:
Hidden cable routing
In order to install the camera with a hidden cable laying you need to drill a hole into the surface and
put through the cable. The camera bracket will cover the cable gland.
Surface cable routing
There is one knock out at the bracket base side to do
surface cable routing.

6.3 Power supply

Before you start with the installation please make sure that the main voltage and the nominal
voltage of the camera comply together.
TVCC40000, TVCC40030
The camera is run by a 12VDC power supply. Please observe the polarity. In order to connect a
power supply a DC connector (5.5mm x 2.1mm) is preinstalled.
1
2
(1) Video signal (BNC)
(2) Power supply
22
12VDC