Install Oven; Install Deflector Kit Bracket - Jenn-Air JJW2427DB Instructions D'installation

1. Using two or more people, lift the oven partially into the
cabinet cutout. Use the oven opening as an area to grip.
NOTE: When pushing the microwave oven into the cabinet,
open the microwave oven door and push against the seal
area on the front frame. Do not push against the outside
edges.
2. Push against the front frame of the microwave oven to push
oven into cabinet.
3. Push oven completely into the cabinet and center the oven
into the cabinet cutout.
4. Remove the tape from the black front trims and remove the
zip tie from the mounting spacer.
Securely fasten the oven to the cabinet using the
■
#8-14 x 3/4" (1.9 cm) screws provided.
Insert the screws through holes in black trim aligning with
■
holes in oven frame and mounting spacer already in place.
A
B
C
D
A. Oven Frame
B. Mounting spacer
C. Oven frame hole
D. Black trim piece
06-May-2019 13:38:41 EDT | RELEASED

Install Oven

B
In some European factories the letter "W" of the part code mentioned herein will be automatically

Install Deflector Kit Bracket

This assembly is required for use when a single or double built-in
oven is installed in a flush installation
1. Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the deflector bracket (B) between them.
Some force may be required to flex the upper vent trim (C)
away from the lower vent trim (D). Some force may also
be required to flex the deflector bracket (B) and slide it
into position. Make sure screw holes are properly aligned
between the two pieces. See the following illustration.
2. Install the deflector bracket (B) to the lower vent piece (D)
using two #8-18 x 1/4" (6.3 mm) screws on each side.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.3 mm) screw is used on each side.
A
A. #8-18 x 1/4" (6.3 mm) screws
B. Deflector bracket
3. Align vent tab (B) with oven frame (A) as shown in the
following illustration.
4. Using one #8-18 x 3/8" (9.5 mm) screw (E) on each side of
the vent tab (B), fasten the vent securely to the oven.
E
D
A. Oven frame
B. Vent tab
C. Oven vent
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
B
C
B D
C
D
C. Upper vent piece
(supplied with oven)
D. Lower vent piece
(supplied with oven)
A
B
C
D. Deflector bracket
E. #8-18 x 3/8" (9.5 mm)
screw
9