Cleaning, Maintenance And Storage Of The Pole Trimmer; Battery-Powered Telescopic Handle; Safety Instructions - IKRA AAS 4025 Manuel D'utilisation

To use the Pole Trimmer for trimming low- lying foliage
or ground cover, hold the Pole Trimmer at the position
as shown.
Use the Pole Trimmer properly. Always wear eye protec-
tion, rubber gloves, and substantial foot wear while using
the Pole Trimmer. Always maintain proper footing and
balance and never overreach when using Pole Trimmer.
Before starting the Pole Trimmer, hold the unit with both
hands on the grip areas. Make sure that the cutter blade
is not touching anything.
Always keep the extension cord behind the Pole Trimmer
when in use. Do not drape the cord over the hedge where
it may be cut by the blades. Use smooth steady sweeping
motions to trim new growth. Do not try to cut too much at
one time. This can cause the Pole Trimmer to slow down
or get jammed, reducing the cutting efficiency.
Do not force the Pole Trimmer through dense growth. A
slight back and forth sawing action may ease the cutting
of larger, more dense growth. If the Pole Trimmer begins
to slow down, reduce the rate of speed at which you
are trying to cut. If the Pole Trimmer becomes jammed,
immediately turn Pole Trimmer off. Disconnect Pole
Trimmer from the power supply and remove the jammed
debris from the cutter blades.
Do not try to cut branches larger than 18mm in diameter.
For best results, trim the sides of hedges with an upward
sweeping motion. Trim the hedges so that the top is
slightly narrower than the bottom.
Cleaning, maintenance and storage of the pole
trimmer
WARNING: Always remove the battery before
inspection and adjustment work. Severe injury or
death could occur from fire, electrical shock, or
body contact with moving cutter blades.
WARNING: When cleaning Pole Trimmer:
- Do not submerse Pole Trimmer in any liquids.
- Do not use products that contain Ammonia, Chlo-
rine, or abrasives.
GB | Operating Instructions
Use a soft cloth dampened with a mild soap and water
mixture to wipe Pole Trimmer pole, housing, and cutter
blades clean. Do not spray or pour water directly onto
Pole Trimmer.
• Keep cutting edge sharp and clean for best perfor-
• Follow instruction for lubricating and changing ac-
• Keep handles dry, clean, and free from oil and grease.
1. Check Damaged Parts
2. When servicing Pole Trimmer, use only identical
3. Store Idle Pole Trimmer Indoors.
When not in use, the Pole Trimmer should be stored
indoors in a dry location. Store Pole Trimmer above the
reach of children or in a locked area out of the reach of
children.

2. Battery-powered telescopic handle

Safety instructions

Attention! Read all instructions contained here-
in. Failure to observe the following instructions
may result in electric shock, burns and/or severe
injury. The term 'power tool' used in the follow-
ing includes both mains-operated tools (with
mains supply) and battery-operated tools (with-
out mains supply).
KEEP THESE INSTRUCTIONS CAREFULLY!
1) Working area
9
- Do not use chlorinated cleaning solvents, Carbon
Tetrachloride, Kerosene, or Gasoline.
mance and to reduce the risk of injury
cessories.
• If a part is damaged, carefully check the damaged
part before using the Pole Trimmer. Make sure the
part will operate properly and perform its intended
function.
• Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any
other condition that may affect its operation.
replacement parts.
a) Keep your working area clean and tidy.
Untidy and poorly lit working areas may
lead to accidents.
b) Do not operate the tool in potentially
explosive environments containing com-
bustible fluids, gases or dusts. Power
tools generate sparks that may ignite dusts
or fumes.
c) Keep children and other persons away
when you are operating the power tool.
Distractions may result in the operator loos-
ing control over the tool.