Publicité
RISK REDUCTION
It has been reported that vibrations from hand-held tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
upon exposure to cold. Hereditary factors, exposure to
cold and dampness, diet, smoking and work practices
are all thought to contribute to the development of these
symptoms. There are measures that can be taken by the
operator to possibly reduce the effects of vibration:
Keep your body warm in cold weather. When operating
the unit wear gloves to keep the hands and wrists
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
use of a tool. When using any tool for prolonged periods,
ensure you take regular breaks.
MAINTENANCE
WARNING
The product should never be connected to a power supply
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
WARNING
When servicing use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Electrical tools used on fiberglass material, wallboard,
accelerated wear and possible premature failure
2
| English
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, and commutators. We
do not recommend using the product for extended
periods of time on these types of materials.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorised service
centre to avoid risk. Contact authorised service centre.
For greater safety and reliability, all repairs should be
performed by an authorised RYOBI service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
the product under normal operating conditions.
LUBRICATION FOR GEAR BOX
Add 10g of grease after 45 hours continuous use or after 55
hours accumulative use into the gear box.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety alert
V
Volts
Hz
Hertz
Alternating current
W
Watts
n
No-load speed
o
Revolutions or reciprocations per minute
Please read the instructions carefully before
starting the machine.
Wear eye, hearing and respiratory protection.
CE conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Publicité
