Mounting The Wall Bracket (E); Before Starting The Vacuum Cleaner; Charging The Appliance; Dry Vacuuming - Rotel Accucleaner Wet'n'dry U606CH1 Mode D'emploi

• MOUNTING THE WALL BRACKET (E)

Choose a sheltered spot on a wall near an electric plug socket. Mark out where the
o
holes are going to go, drill the holes and attach the wall mount with the screws sup-
plied. The two nozzles (F1-F3) can fit on the wall mounting, too.

• BEFORE STARTING THE VACUUM CLEANER

The battery cells in new appliances are not charged yet. That is why you must charge
o
up the vacuum cleaner for about 10 hours before its first use. After which, the appli-
ance will have reached its full capacity.
To make sure that the vacuum cleaner is ready for use at all times, you can charge it
o
again immediately after using it.
Caution: To avoid reducing the operating time of the appliance, we recommend

that you discharge the appliance completely from time to time, after which the
battery must be charged again for 10 hours.

• CHARGING THE APPLIANCE

Put the vacuum cleaner in the charging station (E). This automatically connects it to
o
the power supply.
Connect the charger plug to a 230 V socket. When the red charging light (C) lights up,
o
it means that the appliance is being charged.
Whilst it is charging, the charger plug may become warm, this is completely normal.
o
It is not possible to overcharge the battery.

• DRY VACUUMING

Turn the appliance on (D) and clean the surface or object. To remove dust from crev-
o
ices, skirting boards, corners, drawers, etc., you can use the rigid crevice tool (F3).
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
23