Brandt TI216 Guide D'utilisation Et D'installation page 11

9962 6151.qxd 18/09/02
Minor troubleshooting
You have doubts about whether your hob is working correctly .... ...... this does not
necessarily mean there is a breakdown. Nevertheless, check the following points
IF YOU REALIZE THAT
When you switch on, the display lights up
When you switch on, the fuse blows
When you switch on, only one side of the hob
works
The fan keeps going for a few minutes after the hob
has been switched off
The hob doesn't work. The display lights don't
come on
The hob has stopped during use and is giving out a
bleep every ten seconds and a
pears on the display.
A series of little (or F7 ) appears
The hob does not work, another message is
shown.
The pilot lights in the control panel continue to flash
even after the cooking zone has been turned on.
The pans make a noise during cooking
The hob gives off a smell when first used for
cooking
If the slightest break or crack appears in the ceramic glass surface, disconnect the
unit immediately and contact your After Sales Service.
16:01 Page 11
POSSIBLE
CAUSES
The hob is working normally
Your hob is connected incorrectly
Your hob is connected incorrectly
The electronics are cooling down
The apparatus is not under power.
There is a power or connection problem.
Something has overflowed and or an
(or F7 ) ap-
object is touching the control panel.
Electronic circuits have overheated.
The electronic circuit is working badly.
The saucepan you use is unsuitable for
induction cooking or its diameter is
under 12 cm. (10 cm on the 160 mm
zone).
This comes from vibrations made by
energy going from the hob to the pan.
A new apparatus
11
WHAT SHOULD
YOU DO?
NOTHING: see chapter Remarks on
connections
Check the connection and make sure it
complies with requirements.
This is normal.
Inspect the fuses and the cut-out
switch.
Clean the hob or remove the object in
question and start cooking again.
See "Fitting your hob".
Call the After Sales Service
See containers.
Under high power this phenomenon is
normal with certain types of pans. There
is no danger for the hob.
Use each heating zone for ½ hour
with a pan full of water.