Quick TCD 1044 D Mode D'emploi Et D'installation page 18

OPERATING
GB
REMOTE CONTROL ENABLING
To enable the remote control, press the enabling button and keep it pressed for at least 1 second.
After this period the enablement LEDs will start fl ashing with greater frequency and the control will emit a short
sound.
Release the enablement button, the enablement LEDs will remain steadily lit on and the remote control will be
enabled. In this condition the control will emit a short sound every 5 seconds.
THRUSTER ACTIVATION
Bow thruster activation
When the propeller is activated the direction led corresponding to the imparted movement (red to the left, green
to the right) will light on and the control will emit an intermittent sound.
WARNING: once the direction joystick has been released, the boat will continue to move according to the
inertia of the movement.
18
To move the bow to the right, move the bow
joystick to the right at the end of its stroke.
To move the bow to the left, move the bow joy-
stick to the left at the end of its stroke.
TCD1044 D - REV002A