EINHELL BT-PO 1100 E Instructions De Service page 8

Anleitung BT-PO 1100 E SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1. Spindle lock
2. Front grip
3. ON/OFF switch
4. Speed control
5. Rear grip
6. Power cord
7. Polishing / sanding disk
3. Proper use
The machine is designed for polishing coated
surfaces and for sanding wood, iron, plastic and
similar materials using the appropriate abrasive
paper.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
8
11.02.2008 8:51 Uhr Seite 8
businesses or for equivalent purposes.
4. Technical data
Voltage:
Power rating:
Speed:
Polishing / sanding disk diameter:
Connection thread:
LWA sound power level:
LPA sound pressure level:
Vibration aw
Totally insulated
Weight:
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6. Starting up
6.1 Assembly (Fig. 3-6)
Important! Pull out the mains power plug before
starting the assembly work.
6.2 Using as a polishing machine
When using waxing and polishing agents,
observe the instructions issued by their
manufacturer!
IMPORTANT!
To prevent damage to the surfaces of the workpieces
you wish to polish, make sure that you observe the
following instructions:
Make sure that the polishing attachment is always
mounted precisely in the center of the
sanding/grinding disk.
Before you start the equipment, check to ensure
that the attachments are securely installed.
Never touch the area you wish to polish with the
edge of the sanding/grinding disk.
Use the speed selector (Fig. 2/Item 4) to select the
following maximum speeds for polishing:
- Working in polish:
- Polishing to a high gloss: approx. 1000-1100 rpm
- Polishing up:
If you do not comply with these instructions, the
manufacturer cannot accept any liability.
230V ~ 50 Hz
1100 W
1000-3000 min -1
180 mm
M14
98 dB(A)
87 dB(A)
6,76 m/s 2
II/
2.2 kg
approx. 1000 rpm
approx. 1400 rpm