Publicité
Les langues disponibles
Les langues disponibles
English
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Fig. D
12
Extendable Crevice Tool
1. To extend the crevice tool
vacuum nozzle
3
until it clicks in place.
2. To collapse the crevice tool
nozzle
3
until it clicks in place.
Attaching Motorized Brush (Fig. G)
CAUTION:
off when the motorized brushis attached or detached.
nOTE: Do not use directly on pets.
1. Slide the vacuum nozzle
motorized brush
10
.
2. Ensure that the plastic retaining tabs
the recesses
13
. An audible click will be heard.
Fig. E
3
13
4
2
4
, pull it out from the
4
, push it into the vacuum
The unit needs to be switched
3
into the opening of the
12
engage with
10
12
Removing motorized brush
CAUTION:
off when the motorized brush is attached or detached.
1. Pull the the plastic retaining tabs
from the recesses
13
2. Pull the vacuum nozzle
Dry pick up
For everyday spills of dry material.
-
Do not fill the dust bowl
filter.
Optimizing the suction force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filter (Fig. E, F)
WARNING:
should be cleaned regularly.
1. Hold the dust bowl over a trash can before pressing the
dust bowl release button
access door
as shown in figure E.
11
2. While holding the dust bowl over a trash can, lightly
shake it to empty the dust bowl
3. Lift the prefilter
out of the dust bowl
12
in figure F.
4. Lift the filter
out of the dust bowl
13
5. While holding the dust bowl over a trash can, empty the
dust bowl
.
5
6. Install the filter
13
into the dust bowl
the prefilter
into the dust bowl
12
7. Close the dust bowl access door
into place.
WARNING:
without the filters. Optimum dust collection will only
be achieved with a clean filter.
Fig. E
11
The unit needs to be switched
12
outward, away
.
3
from the motorized brush
5
beyond the end of the
The filter is reusable and
to release the dust bowl
6
.
5
as shown
5
.
5
5
, then install
.
5
11
until it clicks firmly
Never use the appliance
6
10
.
Publicité
