Publicité
Les langues disponibles
Les langues disponibles
MOUNT THE RIP FENCE (FIG. 8&9)
Loosen the rip fence lock knobs(24) on the
sliding block(19), then slide the fence(6) onto
the bolt heads and tighten the rip fence lock
knobs(24) (Fig. 8)
To lock the rip fence(6), slide the rip fence
assembly until the indicator is pointing to the
ADJUSTMENT OF SAW BLADE (FIG. 10, 11&12)
WARNING!
• Do not use saw blades which are damaged
or deformed.
• Use only saw blades recommended by
the manufacturer.
• Take care that the selection of the saw
blade depends on the material to be cut.
The Blade(15) has been adjusted at the
factory, use a square to check that the blade is
o
at a 90
angle to the table (Fig.10)
When the machine is connected with the
power supply, the live indicator (26) will glow.
OPERATION ON/OFF MAGNETIC SWITCH (FIG. 13)
The magnetic switch is a safety feature of the
machine. Should the supply be interrupted the
switch will automatically default to the "OFF"
position preventing a dangerous unexpected
startup of the machine when the supply is
restored.
OVERLOAD RESET BUTTON (FIG. 13)
Your table saw features an overload reset
button(14). In the event that your saw turns
off during operation, turn the saw off and
allow
the
motor
to
approximately 3 minutes.
button(14) and attempt to turn the saw on
again.
If the saw does turn on, turn the
switch off and check all cords for proper
connection and retry. If it turns on and then
Live Indicator (FIG. 11)
cool
down
for
Push the reset
12
desired setting. Then press rip fence lock
handle (3) downwards (Fig.9), to lock the
fence into position.
Ensure the fence is locked before operating
the saw.
If adjustment is needed turn the tilting lock
nut
(while holding the adjustment in
position) to fix the adjustment.
Then loosen the indicator fixing screw, set
the indicator of the scale (12) on the "0
marked then tighten the fixing screw (Fig.
11)
o
After the 90
setting of the blade has been
adjusted turn the tilting handles to the 45
(Fig.12) side and adjust the 45
Turn the adjustment nut so that the blade is
o
on the 45
position and then tighten the lock
nut.
If not, please check if the power plug is well
connected
Press the 'ON'
button to start the
machine.
Press the 'OFF'
button to stop the
machine.
WARNING: Before turning the machine
ON, make sure he blade guard is
correctly installed and operating properly.
cuts off while you are working, you may be
trying to feed the workpiece too quickly or
may be operating with a dull blade or may
trying to operate on an insufficient voltage.
o
"
o
o
angle.
Publicité
