Carrera RC Fire Fighter Watergun Instructions De Montage Et D'utilisation page 10

Charging the rechargeable battery Aufladen des Akkus Aufladen des Akkus Aufladen des Akkus
1
2
RED = Charging GREEN = Ready
Einsetzen des Akkus Einsetzen des Akkus Installing the rechargeable battery Einsetzen des Akkus
1
2
Inserting the 9 V block battery Einsetzen des 9 V-Blocks Einsetzen des 9 V-Blocks Einsetzen des 9 V-Blocks
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green.
The battery can now be disconnected and
installed in the Carrera RC car.
The car is now ready for use.
After use, the battery must be allowed to cool
down for at least 20 minutes before it can be
fully recharged. Failure to observe this
pause may damage the battery.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC car.
Connect the end of the cable from the Car-
rera RC vehicle with the charged battery. Put
the battery in place.
Replace the compartment cover using
a screwdriver.
Unscrew the cover of the battery compart-
ment in the controller and insert the 9 V
block battery.
When inserting the 9 V block battery, ensure
that the polarity is correct. Replace the cover
using a screwdriver.
Now you can drive the car
1
2
3
4
5
Let's practise!
18km/h
1
2
• Never run more than 2 batteries down one after the other. After running down two
fully­charged batteries, a pause in running for at least 20 minutes is essential.
• Avoid constant motor operation.
• If the car switches itself off several times one after another, the battery is de
Please recharge the battery.
10
Make sure that nobody in your vicinity
is using the same frequency.
To avoid this and to ensure that your
vehicle will receive the signal from your
controller, make sure that both your car
and the controller are set to the same
frequency (A/B/C).
The use of different channels allows
three vehicles to be operated at the
same time.
Pull out the antenna of the controller to
its full extent.
Switch on the Carrera RC car using the
ON/OFF switch. Your Carrera RC car
has two speeds.
The ON/OFF switch is also used to
select the training or indoor mode.
Adjusting the steering
If the Carrera RC vehicle is found to pull
towards the left or right while moving,
use the adjuster control shown in the
illustration to adjust the car's track pre-
cision.
CAUTION! This vehicle reaches
speeds up to 18 km/h (11 mph). Practice
on an empty surface at least 2.5 metres
(8.2') square. When first starting, be
very careful when operating the gas
pedal, as the car reacts very quickly.
Practice running slowly for at least two to
three full charges of the battery before
you start practising faster manoeuvres.
Now it's time to practise! Set up a Car-
rera RC vehicle racing track in a large
empty area, using cornerposts, empty
cans, or similar objects. The basic tech-
nique to adopt when operating a Car-
rera RC is to drive fast on the straight
sections and to slow down in the
curves.