Publicité
Les langues disponibles
Les langues disponibles
6. CONNECTION TO A DRAIN PIPE - LIFTING PUMP (optional)
This dehumidifier a
This dehumidifier can be connected directly with a fixed draining
pipe; in this case, the water tank must be removed to allow for the
connection of the pipe to the connection fitting.
For the connection, use one pipe provided with a ¾" female fitting
at one end.
In the machines with ball-cock, if the water tank is not fitted in,
the machine will not work.
Some have machines have a switch in order to allow the
functioning without water tanks, in other machines one must
modify the tongue-shaped device placed near the ball-cock.
In the machines with tank placed in the front, one special fitting,
which is supplied with the machine, must be placed on the right
upper side of the water tank room, and must be used also the
supplied rubber device to block the microswitch lever which is
located on the left upper side of the water tank towards the front
part.
Machines with condensed water lifting pumps
This machine includes a condensed water lifting pump.
Put the rubber pipe of the pump supply in a waste pipe or similar. Pay attention
that the pipe be no choked up because of eventual narrow bends.
The pump will work automatically, controlvoyant by a ball cock placed inside the
pump.
Before moving the machine, push the button placed on the pump to empty the
tank of the pump.
If the pump cannot work correctly, the compressor stops and the green light
turns on. In this case, check the pipe situation.
pressure of the pump is about 3.5-4 meters.
AIR FILTER CLEANING
The only required periodical maintenance is the cleaning of the filter once every month, or more often if the enviroment is very
dusty or the dehumidifier is working for many hours every day.
The cleaning must be done by placing the filter under a water jet with the drilvoyant panel facing the floor so that the water jet may
push the filter towards the drilvoyant panel.
After a few years running, may be necessari to make a cleaning of the warm heat exchanger (condenser) by using compressed air.
This operation must be done by a specialized technician. This cleaning will improve the performaces and the long life of the machine.
Note: You can require spare filters from your dealer's service.
Maximum head working
7. PERIODICAL MAINTENANCE
Fig. 1
Fig.2
Publicité
