Assembly Of The Landing Skid; Assembly Of The Propeller; Bottom Connectors - XciteRC Rocket 400 GPS Mode D'emploi

Assembly of the landing skid

1. Place the landing skid on the designated positions and
lock with the accompanying screws.
EN
WARNING: Mind the antenna, it has to be placed in
the notch (see red markings) of the Quadrocopter shell and
the landing skid – do not pinch - danger of falling!
2. Fix the antenna with double-sided adhesive tape in the
landing skid (see figure).

Assembly of the propeller

1. The arrow of the propeller has to point upwards. Mind that the running direction on the Quadrocopter
pipes, and the running direction of the propeller have to be identical (see figure)
2. Fasten the propeller with the appropriate nut, silver for clockwise motors, black for counter-clockwise
motors.
WARNING: Tighten the nut firmly – danger of falling!

Bottom connectors

• The terminals S1 and S2 are proportional outputs, which are cont-
rolled via the rotary knob AUX1 and AUX2 on the transmitter. Here
you may connect the camera # 15001119 an control the tilt.
• At the terminals G+ 12V suitable accessories (eg. gimbals) can be
powered.
• The USB port is reserved for future special features.
20
Assembly · Bottom connectors
XciteRC Rocket 400 GPS