The Remote Control System; Transmitter; Battery Charging - XciteRC Rocket 260 3D Quadrocopter Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your XciteRC Rocket 260 3D and its various fea-
tures and settings. Before the first flight, you should absolutely have read and understood all these functions
EN
and settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Slide the cover down (1).
• Insert three size AA Alkaline batteries (2).
• WARNiNG: pay attention to the correct polarity - fire or explosion hazard!
• Close the battery compartment cover, then turn on transmitter.
• The POWER LED must lit. Attention: if the POWER LED flashes and a beep sound appears or does not
light at all, the model may not started – crash hazard! Change transmitter batteries immediately.
• WARNiNG: check the POWER LED also during operation. If the POWER LED starts to blink and
the sound appears, stop operation, switch the model off and replace the transmitter batteries – crash
hazard!
• ATTENTiON: The maximum range of the remote control system is about 50 meters, do not fly
farther away under any circumstances - crash hazard!

Transmitter

Throttle lever
(Rise/sink,
yaw left/right)

Battery charging

WARNiNG: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
USB Ladegerät
• Connect the USB cable to a PC or appropriate power supply. The red LED lits.
• Connect the Quadrocopter battery with the charger.
18
The remote control system · Battery charging
+
-
Direction lever
(forward/backward,
left/right)
Power-LED
Power Switch (ON/OFF)
COM P U TE R
U S B
LiPo-Akku
-
+
-
+
Throttle rate
Battery level
L.H
H
E ASY
%
XciteRC Rocket 260 3D