Description - Hilti PS 30 Mode D'emploi

Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer

2 Description

2.1 Use of the product as directed
The Hilti PS 30 Ferrodetector is designed to detect ferrous metals (steel rebars) and non-ferrous metals (copper and
aluminium).
The tool is not suitable for locating tensioning cables.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Take the influences of the surrounding area into account. Do not use the tool or appliance where there is a risk of fire
or explosion.
Modification of the tool is not permissible.
2.2 Display
The settings and tool status are shown in the display.
2.3 Display illumination
The display illumination switches on automatically in conditions of low ambient light.
2.4 Display
Areas of the display
2.5 Status indicator
Status area
2.6 Symbols in the display
Audible signal
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
1
2
Shows the two areas of the display.
1 2 3
Shows which status is active
active (left)
inactive (right)
Status area
@
Detection area
;
Ferrous metal object
@
Non-ferrous metal object
;
Audible signal off
4
=
Battery status
%
en
11