Assembly - QEP 22650Q Manuel D'utilisation

Rip Guide
Angle Guide
On/Off
Switch/Key
FIGurE 3
PrOdUCt SPeCiFiCatiOnS
Input: 4.8 Amps
No-load Speed: 3600 rpm
Output: 3⁄4-peak hp
Blade Diameter: 7 in. (180 mm)
Arbor: 5/8 in.
Rating: 120 volts~60 hz Ac
Depth of Cut: 1 1⁄4 in. (31 mm)

ASSEMBLY

ASSEMBLY AND OPERATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE
SAW TO A POWER SOURCE OR TURNING THE
MOTOR ON.
UnPaCKinG
1 . Remove all packing materials from around
your saw .
2 . Carefully lift the saw from carton and place
it on a level work surface .
3 . Do not discard the packing materials until
you have carefully inspected the saw for loose
or damaged parts .
The following items are included in box with
your tile saw: 7 in diamond blade, blade
Water Reservoir
FOLLOW ALL OF THE
Blade Guard
Right Cutting Table
Guard, rip Guide, Angle Guide, Extension
Table, universal Wrench and owner's manual .
4 . Inspect the saw carefully to make sure that
no breakage or damage has occurred during
shipping . If any parts are damaged or missing,
return the saw to your place of purchase .
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.
inStaLLinG tHe BLade
1 . Remove right cutting table .
2. Remove baffle (see FIGURE 4)
FIGurE 4
– 5 –
Extension
Table
Bottom
Cord Storage
IF ANY PARTS ARE