Program Mode; Basic Navigation - Hedson IRT 3-1 PcD Mode D'emploi

7. Program Mode – General rules for navigation in the software
– The display shows software defi ned options in the bottom corner fi elds.
– To adjust the values use the arrow keys.
– To move to previous display without saving, press cancel.
7.1

Basic navigation

There are twelve predefi ned programs and three empty ones. All 15 programs have editable positions, names and drying parameters.
Scroll up or down using the arrow keys, press select to run the program or view to edit.
1. Putty
2. Filler Bright
3. Filler Dark
4. Waterbase
5. Basecoat
6. Topcoat
7.2
7.2.1
The distance is indicated on the display as "too
close", "too far" or "correct". If measuring fails
"check distance manually" appears.
Use the cassette button to alter between one or
Stop or cancel
two active cassettes.
returns to 7.1.
7.2.2
Press start to begin the drying sequence. The
remaining time of the "fl ash off" will start
counting down. When the "fl ash off" is fi nished,
the program automatically changes to full bake
mode.
7.2.3
Press view and the screen shows the values
for power (0–100 % of machine capacity) and
energy consumption of current drying process.
7.2.4
Total energy consumption per drying process is
shown for the last 10 runs.
7.2.5
When fl ash off and full bake times have
expired the software returns to 7.1.
Note! To extend the lifetime of the lamps, the
ventilators will continue to run for cooling. After
three minutes they turn off automatically.
713686 rev 7
7. Clearcoat
8. Plast Filler
9. Plast Topcoat
10. Plast Clearcoat
11. Final boost
12. Soft cure
Run
Distance check
Start dryng
Program values
Energy consumption
Drying complete
IRT 3-1 PcD, IRT 3-2 PcD and IRT 3-20 PcD
13. Free prog
14. Free prog
15. Free prog
7.3
7.3.1
The values of the chosen program will show on the
display.
7.3.2
Stop or cancel
Use the arrow keys to set the correct digit. Press
returns to 7.1.
enter to confi rm and to edit the second, third and
fourth digit of the advanced PIN code.
Note! An entered PIN code is valid for all entries
until the main switch is turned off.
See chapter 8.2 for "advanced PIN code".
Use arrow keys
7.3.3
to set numbers.
When marked, change the value of the parameters
with the arrow keys. Press enter to change the next
value and so on. Pressing enter for the last value
directs the user to editing of program position and
name.
Press cancel to exit without saving any parameters.
The program returns
7.3.4
to 7.3.1.
When marked, change the program number with
the arrow keys. Press enter to confi rm and to edit
the next symbol.
Note! Changing the number will also change the
program position in the program list.
The program returns
7.3.5
to 7.3.1.
When the drying process requires more than the
two standard steps, you can expand the number
of steps in the drying cycle by linking to the next
program.
Start from point 7.3.4 and press Enter repeatedly
until the Link to next program appears on the
screen. Select with the arrow keys Yes or No, and
then press Save. The link to the next program will
The program returns
remain until it is deactivated (No). Use the program
to 7.3.1.
13, 14 or 15 as these are free programs without
any default.
Edit
Properties
PIN Code
Edit program parameters
Edit program position/name
Expansion of the program steps.
5