Safety Instructions; Assembly Instruction; Basic Instruction For Operation; Program Mode - Hedson IRT COMBI 4-1 IR/UVA Mode D'emploi

4. Safety instructions

The mobile dryer must not be exposed to paint fog, sanding dust or
solvents, due to fire hazard. Furthermore, this will reduce the
lifetime of the dryer. Allow for sufficient cooling time of the dryer.
The distance to the object that is to be dried must be sufficient.
Otherwise there is risk for fire or explosion! Keep all flammable
materials in a sufficient distance from the hot surfaces of the dryer.
4.1 Hazards
Tilting
The risk for tilting increases when the arm is located in an upright
position. Turning both cassettes to one side also increases the risk
for tilting.
Fire and explosion
Do not store, prepare or use solvent-containing materials within a
5 m/16 feet radius of the mobile dryer. Flammable materials should
not be placed close to a drying device in use.
With the temperature control turned off, the temperature might
raise quickly and the risk for fire increases, especially if you have a
distance less than 60 cm/24" to the object. Never direct the
cassette towards highly combustible materials.
Electrical equipment
The mobile dryer is operated with high electrical voltage, which can
be highly dangerous.
Before accessing live parts, remove the main connector from the
wall socket. Only professional electricians may have direct access to
the electrical components.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
WARNING!
Intensive heat radiation. Hands, face and other parts of the body
should be exposed as little as possible to the heat radiation.
UV radiation can cause injury and property damage!
• To reduce risk of injury or property damage from UV radiation,
read, understand, and follow the following safety instructions.
In addition, make certain that anyone else that uses this heating
equipment follows these safety instructions as well.
• Hands, face and other parts of the body shall not be exposed to
heat and radiation. Do not stay in front of the lamp cassettes during
curing without safety equipment.
• Always wear eye protection. Failure to this may result in
longterm injury to the eyes.
• If a person works around UV radiation while on medications, the
medication should be checked to see if it would make the person
more photosensitive.
• Do not look directly at the light source.
• Do not use if protective glass is broken or missing. This glass filters
the light from unwanted radiation.

5. Assembly instruction

See separate document for detailed instructions.
For mobile dryers:
714838 IRT COMBI 4-1 & 4-2 IR/UVA Mobile Assembly Instruction
For rail systems:
713683 IRT Pc Auto 4-10 & 4-20 Rail System Assembly Instruction
714812 rev 2

6. Basic instruction for operation

6.1 Keyboard
Software defined button
Confirmation choices
Cassettes in use
(one or two
6.2 Display
Flash off – active
Full bake – inactive
Confirmation choices
6.3 Program mode –
General rules for navigation in the software
6.3.1

Program mode

This mode is for your everyday use. It helps you run the dryer with
preinstalled programs and edit program settings.
To enter the program mode, turn the main switch on.
When you start the dryer, an information screen will appear for two
seconds. By pressing the confirmation or cancellation button this
information will show until released. The diagram shows cassette filter
usage and notifies when it's time to change filter. To replace filter see
chapter "11.1 Filter replacement".
6.4 Settings mode
The Settings mode enables you to change advanced system
parameters. Thanks to our advanced control system in this mobile
dryer there are many settings that can be altered. This is normally not
a part of the everyday usage.
To enter the settings mode press both arrow keys when you turn the
main switch to position 1. For further information see Chapter 9.
GB
Software defined button
Cancellation choices
Start
Enter
Stop
Temperature control
) (on/off)
Active program
One cassette active
Temperature reading
Cancellation choices
5