Hitachi NV 45AC Mode D'emploi Et Instructions De Securite page 15

NOTE:
The information contained in this Manual is designed to assist you in the safe maintenance of
the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on
your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 6).
WARNING
Disconnect air hose and remove all nails from
Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
Never use gasoline or other highly flammable
liquides for cleaning.
1. Clearing a jam
Remove a jammed nail in the following order :
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
4 Remove the jammed nail with a slotted screw
driver.
Nail
Slotted Screw Driver
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact a Hitachi authorized
service center.
MAINTENANCE
2. Inspecting the feeders
Rod
Outlet
1
Disconnect
air hose
— 15 —
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Knob
Nail Guide
3 Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
CAUTION
Check that nail stopper (A) and nail stopper (B) slide
smoothly by pusing them with finger.
If not smooth, nails can be driven at an irregular angle
and hurt someone.
Nail Guide
Nail Stopper (A)
Nail Stopper (B)
4 Lubricate the feeding surfaces of the nose and the
nail guide after cleaning.
This promotes smooth operation and prevents rust.
English
1 Disconnect
air hose
Shaft
Feeder
Nose