Kenwood KDC-X7200DAB Mode D'emploi page 21

BLUETOOTH®
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –4): The sensitivity of the
microphone increases as the number increased.
NR LEVEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the noise reduction level until
the least noise is being heard during a phone conversation.
ECHO CANCEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the echo cancellation delay
time until the least echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER
BATTERY/
SIGNAL*
.
* Functionality depends on the type of the phone used.
Default: XX
Make a call
You can make a call from the call history, phonebook, or dialing the
number. Call by voice is also possible if your mobile phone has the
feature.
1 Press
"(First device name)" appears.
• If two Bluetooth phones are connected, press
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
Repeat step
the instructions stated on the selected item.
4
Press and hold
.
To return to the previous setting item, press
CALL HISTORY
1 to 30: The unit answers incoming call automatically in the selected
time (in seconds). ; OFF: Cancels.
AUTO: Shows the strength of the battery and signal when the unit
detects a Bluetooth device and the Bluetooth device is connected. ;
OFF: Cancels.
to enter Bluetooth mode.
another phone.
"(Second device name)" appears.
2
until the desired item is selected/activated or follow
to exit.
(Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part
of the display to indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
Default: XX
again to switch to
.
17
ENGLISH