Hitachi DS 12DVF3 Instructions De Sécurité Et Mode D'emploi page 15

Hook
Screw
Fig. 11
Fig. 12
(2) Remove the old batteries and insert the new
batteries. Align with the hook indications and
position the plus (+) and minus (–) terminals
correctly (Fig. 13).
Inden-
tation
N
batteries
Indentation
Fig. 13
(3) Align the indentation in the hook main body with
the protuberance of the hook cover, press the hook
cover in the direction opposite to that of the arrow
shown in Fig. 12 and then tighten the screw.
Use commercially available N batteries (1.5 V).
NOTE:
Do not tighten the screw excessively. Such action
could strip the screw threads.
CAUTION:
● Failure to observe the following can result in
battery leakage, rust or malfunction.
Position the plus (+) and minus (–) terminals
correctly.
Phillips-head
screwdriver
Arrow
Hook cover
Hook main body
Protube-
rance
Protube-
rance
Hook cover
Replace both batteries at the same time. Do not
mix old and new batteries.
Remove exhausted batteries from the hook
immediately.
● Do not discard batteries together with normal
trash and do not throw batteries into fire.
● Store batteries out of the reach of children.
● Use batteries correctly in accordance with the
battery specifications and indications.
2. Using the bit holder.
CAUTION:
● Stow the bit in the specified location on the tool.
If the tool is used with the bit stowed improperly,
the bit may fall and cause bodily injury.
● Do not stow bits that are of a different length,
gauge or dimension than the plus driver bit (65
mm long) included in the STANDARD
ACCESSORIES.
The bit may fall and cause bodily injury.
(1) Removing the bit
Securely hold the main unit and pull out the bit by
holding the tip with your thumb (Fig. 14).
Bit
(2) Installing the Bit
Install the bit with steps opposite of when
removing. Insert the bit so that the right and left
sides are equal, as shown in Fig. 15.
Fig. 15
English
Fig. 14
Insert so that
bit does not
protrude
from main unit
15