Futurelight PCC-575 CMY Mode D'emploi page 48

• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "TIME".
- Fixture running time
With this function you can display the running time of the device.
• Select "MATI" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the number of hours.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Lamp running time
With this function you can display the running time of the lamp.
• Select "LATI" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the number of hours.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Clear lamp time
• With this function you can clear the running time of the lamp. Please clear the lamp time every time you
replace the lamp.
• Select "CLLT" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DN] to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 5
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] to select "EDIT".
- Define the number of steps in Run
With this function you can define the number of steps in the
Program Run.
• Select "STEP" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"S-XX", "X" stands
for the total amount of steps you want to save, so you can call
up to 48 scenes in "RUN". For example if the "XX" is 05, it
means that "RUN" will run the first 5 scenes you saved in
"EDIT".
• Press [MODE/ENTER] to save and exit.
- Auto scenes rec
With this function you can automatically record new scenes.
• Select "REC" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"RE-XX", "X" stands
for the total amount of memorizable scenes, you can call up in
"RUN". For example if the "XX" is 05, it means that "RUN" will
run the first 5 scenes you saved in "EDIT".
• Press [MODE/ENTER] to save and exit.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in
Run.
a) Editing via the Control Board
• Select "SC01" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "SCXX", "X" stands
for the scene no. to be edited.
• Change the scene no. by pressing [UP] or [DN].
48/99 51840965_V_1_0.DOC