Hendi 239698 Mode D'emploi page 8

• If you select temperature control, select "Temp"
using the "Temp/heating" key. Now you can pro-
gramme the required temperature by means of
the arrow keys between 35°C and 240°C in 5°C
intervals.
• After programming the capacity or temperature,
you can opt to programme the timer. This timer
switches the appliance off after the programmed
time has been reached. You do this by pressing
the "Timer" key after programming the capacity
or temperature, and selecting "Timer". You can
now set the desired time. The maximum pro-
grammable time is 180 minutes.
• Once you have reached the required result, you
can switch off the appliance by pressing the "ON/
OFF" key. The display will go off and the lights
next to "Power", "Temp" and "Timer" will go off.
• If you do not use the appliance for an extended
period, remove the plug from the wall-mounted
electrical socket and remove the pans from the
appliance.
Error codes display
Error codes shown on the
EN
display (5)
E01
E02
E03
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning and storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
8
Possible cause
The temperature of the appliance is too high
Cooling fan defective
The temperature of the cookware is too high.
Possibly, the cookware becomes empty and
appliance will shut down for protection.
The supply voltage is abnormal. (Supply volt-
age is too high or too low)
Note:
1. After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in OFF mode for some time. Before unplug
the appliance, wait until the cooling fan stops
running.
2. The appliance's surface is still hot even after
switch to OFF mode. Please wait the appliance
completely cool down before touching or clean-
ing.
3. If no cookware is placed on the heating surface
after switch ON, it will turn to OFF mode auto-
matically within 1 min.
4. If no any button on the control panel is pressed
during operation for 2 hours, the appliance will
then switch to OFF mode automatically.
5. If the appliance beeps after being switched on,
the pan you are using is not suitable for induc-
tion or the appliance is defective. In case of any
doubt, always contact the supplier of your pan!
Possible solution
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Contact the supplier.
Unplug the appliance, remove the cook-
ware, wait until the appliance is com-
pletely cool down.
Make sure that the appliance is connect-
ed to a suitable electrical power supply.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put heavy objects on the heating surface
during storage as it may crack it.