ECG MTD 2390 VGSS Mode D'emploi page 73

INSTALLATION OF THE TURNTABLE TRAY
Hub (bottom side)
Turntable
Support axis
The names of the parts of the oven
A Cabinet 1
B Microwave oven
C Screw 3×20
Remove all packaging material and all accessories.
Check if the oven is not damaged (dented or damaged door, etc.). Do not install
the microwave oven if damaged.
Oven body: Remove all the protective foil from the surface of the oven.
Do not remove the rectangular cover that is attached inside the oven. This
cover protects the magnetron of the oven.
Installation
1. Place the oven on a flat surface with a sufficient amount of space around the
appliance to ensure the proper function of exhaust vents.
a) Do not block the ventilation openings. The oven might be damaged.
b) Place the oven as far as possible from the radio and television.
A microwave oven may cause interference to TV and radio TV signals.
2. Attach the oven in the cabinet using 4 screws (C), see picture.
3. Connect the oven to a standard electricity network. Make sure the voltage
and frequency on the oven label corresponds with the network voltage and
frequency.
WARNING: If the grounded outlet is not accessible after installing the appliance,
the oven must be plugged into a 2-pole branch outlet with a breaker
and a fuse with a 3 mm separation of contacts and located in an
easily accessible place next to the device. The branch outlet must
always be accessible even when the oven is placed in the cabinet.
OVEN FUNCTIONS
Operating instructions
This microwave oven uses modern electronic controls to set cooking parameters to better suit your requirements.
If you press the Stop/Cancel button(Pause/Cancel) during cooking, the program pauses, resume by pressing the Start/Quick start (Start/
Quick start) button. When you press again the button Stop/Cancel the program is cancelled. When the cooking is completed, a beep sounds
and END will appear on the display.
1. Setting the time
Once the microwave oven is plugged into the socket, "1:00" will appear on the oven display and a beep sounds.
Press the Clock/Kitchen Timer (Clock/Kitchen Timer) button for 3 seconds to set the time. Press repeatedly to select 24-hour mode (Hr 24)
or 12-hour mode (Hr 12).
After selecting a mode, set the clock by turning the controller Time/Menu (Time/Menu) and confirm by pressing Clock/Kitchen Timer
(Clock/Kitchen Timer). Use the same procedure to set the minutes.
1. Do not lay the turntable face down. The turntable must always rotate freely.
2. Do not use the oven without the turning ring and the glass tray.
3. All foods and dishes with food must be always placed on the glass tray.
4. If the glass tray breaks or the turning ring is damaged, contact your nearest
authorized service center.
Assembled support
INSTALLATION
1
4
Ventilation opening
1
GB
3
2
73