EUROM WH2000R Mode D'emploi page 13

Remote control
The heater comes with a remote control with 4 buttons:
TIMER
LOW
HIGH
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if the heater cannot
give off enough heat or if it cannot draw in enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the heater too close to a wall or something
similar. When the overheating safeguard switches the heater off, set the mode selector dial to 'OFF' (off), unplug and
allow the heater to cool down. Remove and/or amend the cause of overheating and reuse the heater as normal. If you
cannot find a cause and overheating recurs, stop using the heater, and take it in for inspection/repair.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of overheating so these should be
removed regularly. Switch off the heater, remove the plug from the socket and allow the heater to cool down before
cleaning or carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps, sprays,
cleaners or abrasives, waxes, polishes or chemical solutions!

Using a vacuum cleaner, carefully remove any dust and dirt from the grills and ensure that the air intake and outlet
openings are clean. Be careful not to touch or damage any internal parts during cleaning!

The heater contains no other parts which need maintenance.

At the end of the season, store the cleaned heater in the original packaging if possible. Store upright in a cool, dry
and dust-free place.

Do not dispose of heater with household waste when if becomes worn or damaged beyond repair. Take it to your
local authority's collection point for electrical appliances where any reusable materials will be collected and
redistributed.
CE-statement
Euromac bv, Genemuiden-NL hereby declares that the EUROM Ceramic wall heater with remote control,
type WH2000R, complies with the LVD guideline 2006/95/EG and the EMC guideline 2004/108/EC, and that it meets the
following standards:
EN 60335-1:2012+A11:2014+AC:2014
EN 60335-2-30:2009+A11 :2012
EN 62233:2008
Genemuiden, 29-10-2015
W.J. Bakker, alg.dir.
ON/OFF This is used to switch the heater on or off. The fan begins to
rotate and the fan lamp lights up.
Timer button: use this to set an operational period (see above)
Half power. If you press this button while the heater is in operation, it
will heat at half power (1000W).
Full power. If you press this button while the heater is in operation, it
will heat at full power (2000W).
EN 55014-1 :2006/+A1:2009/+A2:2011
EN 55014-2 :1997/+A1:2001/+A2:2008
EN 61000-3-2 :2014
EN 61000-3-3 :2013
13