Installing The Anti-Tip-Bracket - Thermador T24UR925DS Guide D'installation

Installing the anti-tip-brackets
The appliance includes two anti-tip-brackets. If your cabinetry is not designed for the specific dimensions
of your appliance, or if you plan to use the appliance as a free-standing unit, you should use these
brackets to avoid your appliance tilting due to unbalanced overweight situations where both drawers are
opened at the same time.
WARNING:
To avoid the appliance tilting due to unbalanced overweight do not open both drawers at the same time.
Always close one drawer before pull out another.
For free-standing use
1. Consider the distance necessary for the appliance to be flush with the front of your cabinetry. If
there is no cabinetry, put the unit close to the wall, then take the measurement of the space at the
back, between the unit and the wall.
2. Based on the measured distance between the back of the unit and the wall, bend the anti-tip
bracket (included with the unit) from the pointed lines to form a "step" with the same Distance
measured.
Anti-tip-bracket.
2 pieces.
Bend from here
And here
Adhesive foam
Resultant formed "step".
NOTE: The adhesive foam must be at the bottom of the
step, never on the reverse side.
Distance measured
Page | 11