Thermador T24UR925DS Guide D'installation page 13

For under counter use
1. Consider the distance necessary for the appliance to be flush with the front of your cabinetry.
2. Take the measurement from the top of the cabinet of the unit to the bottom of the counter.
The measurement X"(mm) may vary depending on the design of the counter, extension of the legs
of the product, etc
3. Based on the Distance = X" (mm) between the appliance and the counter, bend the anti-tip-
brackets included with the appliance on the pointed lines to form a "step" 1/16" (2mm) smaller
than the Distance = X" (mm) measured.
Anti-tip-bracket.
2 pieces.
.
Bend from here
And here
Distance= X" (mm)
NOTE: the Distance = X" (mm) may vary
depending on the design of your cabinetry.
Adhesive foam
Resultant formed "step".
NOTE: The adhesive foam must be at the
bottom of the step, never on the reverse side.
Distance = X"- 1/16"
(X mm – 2mm)
Page | 13