Before The First Use; 3/ Using Your Appliance; Filling The Kettle; Connecting The Kettle And Preliminary Installation - Brandt BO1710EX Manuel D'instruction

b) Before the first use
For the 1sst time to use or no use for a long time, it is recommended that you fill to the
maximum level mark with fresh tap water, boil and empty the kettle at least 2 times to clear
kettle of any tiny particles. Do not drink this water.

3/ USING YOUR APPLIANCE

a) Filling the kettle
•
Place the appliance on a dry, flat and stable surface.
•
Remove the appliance from its base. Open the lid and fill the kettle with water.
•
The amount of water is visible through the water level indicator and it should never
be less than the MIN mark (0,6L) and above the MAX mark (1,7L). Be careful, if the
kettle is overfilled, the water may be ejected during boiling.
•
Close the lid and place the kettle on its base unit.
Do not fill the kettle through the spout
Do not open the lid when water is boiling
Contact with steam must be avoided
b) Connecting the kettle and preliminary installation
•
Place the kettle on its base. Unwind the wire from the base and plug it into the
socket.
•
A beep will sound and the display shows "C".
•
Actual water temperature is displayed on the screen (7). No other LEDs are lighted.
c) Using the kettle
•
Choose your heating temperature by pressing the + or – temperature buttons (8).
•
Once temperature is chosen, press the on / off button (10). A red LED lights below
the pictogram indicating boiling (11). The kettle turns on.
•
You can observe the water temperature rise in real time through display.
•
Once temperature is reached, a beep sounds and the red LED which appeared under
the sign indicating the boil turns off.
•
It is possible to keep the water warm for two hours. To do this, press twice on / off
button (10). LED lights under the sign indicating keep warm mode (9).The kettle will
automatically shut off after two hours.
20