Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B. Preparing for use
Before using the first time or after a prolonged period of storage, it is recommended to operate the
kettle for 2 or 3 times following the instructions detailed in the next section.
3/ USING YOUR
APPLIANCE...............................................................................
A. Filling the kettle
•
Place the appliance on a flat, dry, smooth surface.
•
Remove the appliance from its base. Open the lid by pressing the opening button and fill
the jug with water.
•
The amount of water may be seen through the water level indicator and must not be
above the "MIN" level and below the "MAX" mark.
•
If the kettle is overfilled, it is possible that the water may overflow when boiling.
•
Put back the lid and place the kettle back on the base unit.
B. Connecting the kettle and preliminary installation
•
Close the lid, ensuring that it fits hermetically in its place.
•
Place the kettle on its base. Unwind the wire from the base and plug it into the socket.
Do not open the lid when the water is boiling.
Contact with steam must be avoided.
C. Using the kettle and choosing programs
Without setting any function, the kettle will boil until 100°C, shut off automatically and emit a
sound.
To select a particular program, press "Prog" button and choose the temperature:
o "Chaud" for keeping warm: 70°C
o "T.vert" for Green tea: 75°C
o "T.noir" for Black tea: 85°C
o "Café" for Coffee : 90°C
o "Tisane" for Herbal Tea : 95°C
o And "Ebul." for boil : 100°C
Then press the ON/OFF button to validate the temperature. During 3 seconds the LCD display will
indicate the program temperature and then will indicate the actual water temperature. The kettle
as the LCD display will not shut off until the water temp reaches pre-set temperature (except the
keeping warm function). After reaching the pre-set temperature the kettle will shut-off, the
program light will flash on display until the sensor did not work. If you pressed the ON/OFF
button, the function light will stay at previously set position until you change it. When selecting
keeping warm function "Chaud" the LED display indicates –by default- 70°C. It is possible to
adjust the temperature 5°C by 5°C pressing "+" or "-" button. After reached the pre-set
temperature, the system will shut-off and keep warm at the pre-set temperature (during about 20
minutes).
All manuals and user guides at all-guides.com
15
Publicité
Chapitres
Table des Matières
