Operating Instructions - Uberhaus 10625001 Guide De L'utilisateur

ASSEMBLY INSTRUCTIONS
Attach the handle (B) to the top of the heater (A) with the two screws (C) provided
using a Phillips screwdriver (not included).

OPERATING INSTRUCTIONS

1. Place the product upright on a flat, level, stable, heat-resistant
surface. Plug the power cord into a standard 120-volt electrical
outlet.
2. Main Control Knob (Figure 1): Use this knob to set the heat setting:
" " – Fan only (no heat) "Ⅰ(1,300 W)" – Low heat setting "Ⅱ(1,500
W)" – High heat setting
3. Turn the thermostat control knob clockwise to its maximum range.
The power indicator will illuminate, indicating the heater(A) is on.
4. Allow the product to operate until the room temperature reaches the
desired comfort level.
5. Slowly turn the thermostat control knob counter-clockwise until
heater turns off. The heater will cycle on and off to maintain the
setting.
6. To adjust the thermostat, turn the thermostat control knob toward high to increase
the set ambient temperature and toward low to decrease it.
7. If the caution indicator light comes on, the unit has been overheating. If the
thermal cut-out trips, the unit needs to be reset. Before resetting the unit, turn the
control knob to OFF and unplug the heater. Check if the air vents are blocked or if
there is another problem. Once the problem is corrected, wait 10 minutes for the
unit to cool down. After 10 minutes, plug the unit in again and operate normally.
Page 5