Maintenance; Troubleshooting - Uberhaus 10625001 Guide De L'utilisateur

8. Turn off the product by rotating the main control knob to the "0" position, and then
unplug the product from the electrical outlet.
WARNING: Always unplug the product when it will be left unattended or not in use.

MAINTENANCE

WARNING: Do not attempt to disassemble this product for any reason, as incorrect
re-assembly could cause a risk of fire or electric shock. Only qualified service
personnel should perform any servicing.
WARNING: Always unplug the product from the electrical outlet and allow it to cool
before cleaning or storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will
not require further lubrication for the life of the product.
• Clean the exterior surface by wiping with a soft, damp cloth, and allow the product to
dry completely before storing or using. Dust can be removed from vents using a small
vacuum.
• To store, wind and secure the power cord using a twist tie or rubber band, and place
the product in a cool, dry location.
WARNING: Do not allow water or other liquids to enter the interior of the
product. Do not use abrasive cleaners/pads to clean the product.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
1. No electric power.
Your heater 2. One of the safety
shuts off features may have
unexpectedly activated to prevent
or fails to overheating, including
operate. the tip-over safety
switch and thermal
overload protector.
CORRECTIVE ACTION
1. Be sure the power cord is
plugged into a working electrical
outlet.
2. a. Check your thermostat
setting. The heater may be off
because it has reached the
desired temperature setting.
b. Unplug the heater and wait 10
minutes for the unit to cool down.
After 10 minutes, plug the unit in
again and operate normally.
Page 6