Connecting To Your Amplifier - Yamaha NS-C500 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
CONNECTING TO YOUR
AMPLIFIER
Before making connections, make sure that the amplifier is
switched off.
Standard connections
Note
Do not insert the insulation into the hole.
If the connections are faulty, you will hear no sound
from the speaker.
Tighten
Loosen
Black (–)
Insulation coating
NS-C500
Rear view
Amplifier or
Receiver
CENTER
4
En
When connecting the speaker cable
• Do not let the bare speaker wires touch each other as this
could damage the speaker or the amplifier.
• Make sure you connect the speakers with the correct
polarity—positive (+) terminals to positive (+)
terminals, and negative (–) terminals to negative (–)
terminals. If you get them crossed over, the sound will be
unnatural and lack bass.
• Please refer to the owner's manual that came with your
amplifier or receiver.
How to connect the speaker cables
1.
Loosen the terminal knob.
2.
Remove 10 mm (3/8") of insulation from each end of the
cables, and twist the exposed conductors together neatly
and tightly, as shown below.
Red (+)
10 mm
(3/8")
Bare wire
3.
Insert the bare wire.
4.
Tighten the knob and secure the cable.
5.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Note
When using an amplifier with a rated output power higher
than the nominal input power of the speaker, care should be
taken never to exceed the speaker's maximum input.
Speaker
output
terminals
Good
No Good
When using a banana plug
Banana plug
1.
Tighten the terminal knob.
2.
Simply insert the banana plug into the terminal.

Publicité

Table des Matières
loading

Table des Matières