Connecting Your Amplifier/Receiver; Connections; How To Connect - Yamaha NS-IC400 Mode D'emploi

CONNECTING YOUR AMPLIFIER/RECEIVER

Before making connections, make sure that the amplifier/receiver is switched off.
• When connecting, also refer to the owner's manual of the connected equipment.

Connections

• Connect the push input terminals at the rear of the speakers to the speaker output
terminals of the amplifier/receiver with the speaker cables (not included).
• Connect each speaker making sure not to reverse the polarity "+" (red), "–"
(black). If the speaker is connected with reversed polarity, the sound will be
unnatural and lack bass.

How to connect

10mm
(3/8")
Good
3
+
-
NS-IC400 (R)
-
+
R
+
Receiver or
amplifier
Speaker output
terminals
9
En
1
No Good
2
+
-
NS-IC400 (L)
-
+
L
A
- - +
B
1
Remove approximately 10 mm (3/
8") of insulation from the end of
each speaker cable using wire
strippers, and then twist the
exposed wires of the cable
together to prevent short circuits.
2
Press and hold down the speaker
terminal.
3
Insert the bare wire into the hole in
the side of each terminal.
4
Release the terminal.
• Test the firmness of the connection by
pulling lightly on the cable at the
terminal.
CAUTION
• Do not let the bare speaker wires
touch each other as this could damage
the speaker or amplifier/receiver, or
both.