Connecting Your Speakers - Yamaha NS-P125 Mode D'emploi

Connecting Your Speakers

Always turn off your amplifier or receiver before making any connections.
I Preparing Your Speaker Cables
Carefully remove 10 mm (3/8 ")of insulation from both ends of your
speaker cables and twist the bare wires tightly, as shown.
I Hookup
NS-C125
Tighten
Loosen
Notes:
• Make sure that the bare wires are not touching each other as this could damage the speaker and amplifier.
• Connect one speaker to the left terminals of your amplifier, and another speaker to the right terminals, making
sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be
unnatural and lack bass.
I Using a Banana Plug
1. Remove the speaker terminal cover by
gently pulling it toward you.
2. Tighten the terminal knob.
3. Simply insert the banana plug into the
terminal.
+
–
10 mm
(3/8 ")
Good
FRONT
CENTER OR
Amplifier or
SURROUND
R L
receiver
+
–
NS-M125
Banana Plug
3
1
2
No Good
5
E-