emerio FH-125831.1 Mode D'emploi page 7

FH-125831.1
PARTS DESCRIPTION
1. Indicator lights
2. Heat select switch
3. Air outlet grille
4. Handle
5. Power switch
6. Thermostat control knob
Heat setting:
– ON/OFF
– Ventilation
– WARM AIR (low heat output – 900W)
– WARM AIR (high heat output – 1800W)
OPERATION
1. Plug in the appliance and press the power switch to the position "I".
2. Turn the thermostat control knob to the position "MAX".
3. Turn on the appliance by pressing the ON/OFF button.
4. Select the heat setting (ventilation, low heat output or high heat output). When the low heat output is
selected, one half of the air outlet sends out less warm air than the other half.
5. After use, press the ON/OFF button to turn off the appliance. The appliance will stay on ventilation setting
for about 30 seconds to protect the inner system from overheating. After that, switch off the power and
remove the plug from the socket outlet.
SAFETY SYSTEM
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically
switch off the power if it is put on unstable or uneven surfaces or if it is tilted accidentally.
MAINTENANCE
The fan heater only needs regular cleaning on the outside. Do not let water or any other liquids enter into
⚫
the appliance.
Before you clean the unit, turn off the appliance and switch off the power by pressing the power switch to
⚫
the position "O". Remove the plug from the socket outlet and wait until the fan heater cools down
completely.
Use a damp cloth to wipe the heater housing.
⚫
Do not use detergents, abrasive cleaning liquids or chemicals (alcohol, gasoline etc.) to clean the
⚫
appliance.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 1800W
- 6 -
EN