Silencer/Exhaust Opening; Care; Maintenance Schedule; Transport - IKRA IBHS 62 Manuel D'utilisation

Silencer/exhaust opening

Do not retighten the screws on the silencer if the
motor is hot.
1. Check on a regularly basis that the screws (D) in the
silencer (7) have not come undone. If they are loose,
tighten them hand tight.
2. Clean the exhaust opening (E) regularly.

Care

Clean the hedge trimmer carefully after every use, so
that it continues to work properly.
Wear protective gloves when cleaning the cutter!
• Clean the housing with a soft brush or a dry cloth.
Water, solvent and polish may not be used.
• Make sure that the ventilation slots for cooling the mo-
tor remain unobstructed (risk of overheating).
• Clean the cutter regularly with a cloth or brush.
Do not clean the cutter with water, due to the risk
of corrosion.
• Clean and oil all moving parts on a regular basis.
Do not use grease for this purpose! Use environ-
mentally compatible oil.

Maintenance schedule

Task
Adjust the cutter
Set the idling speed
Tighten the screws on the
silencer
Clean or replace the
petrol filter
Clean or replace the air
filter
Lubricate the gearbox

Transport

Switch the motor off to transport the tool and, once the
cutter has come to a standstill, attach the blade guard.
Carry the tool by the front hand grip. While doing so, hold
the cutter facing backwards and keep the hot silencer
away from the body.
Only transport the tool in a car, inside the boot or in a
separate transport area. When doing so, secure the
hedge trimmer against tipping over, damage and leak-
ing fuel.
GB | Operating instructions
Interval
As necessary
As necessary
As necessary
As necessary
Every 8 operating hours
(more often in dusty
conditions)
Every 20 operating hours,
at least once a year

Storage

• Keep the tool in a dry, locked place, with the blade
guard applied, when it is not being used, and out of
the reach of children.
• Before extended storage, please note the following in
order to extend the service life of the hedge trimmer
and guarantee smooth running:
- Perform thorough cleaning
- Treat all moving parts with environmentally friendly
oil.
Do not use grease for this purpose.
- Remove the spark plug connector.
- Slide the transport guard (26) onto the cutter.
- Fully empty the fuel tank.
Dispose of leftover fuel in an environmentally
friendly manner.
- Allow the carburettor to run empty.
12