Control Panel - Kuppersbusch IKEF2480-0 Notice D'utilisation

16
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban re-

Control panel

1 Fridge Pilot light
2 Fridge ON/OFF switch
3 Fridge temperature regulator, + button
4 Fridge temperature indicator
5 Fridge temperature regulator, - button
6 Supercool indicator
7 Supercool button
Switching on the fridge
1. Insert the plug into the mains socket.
2. Press ON/OFF switch .
3. The Pilot Light will light up.
Switching off the fridge
1. Keep ON/OFF switch pressed for more
than 5 seconds.
2. A countdown on the temperature indica-
tor, from -3 -2 -1 will be shown. When
"1" appears the fridge is turned off. The
temperature indicator switches off. The
Pilot light switches off.
Temperature setting buttons
The temperature is adjusted using the tem-
perature setting buttons. These buttons are
connected to the temperature indicator.
• The temperature indicator is switched
over from the indicator of the ACTUAL
temperature (Temperature indicator is illu-
minated) to the indicator of the DESIRED
temperature (Temperature indicator flash-
1 2 3
fuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
4 5 6 7
es) by pressing one of the Temperature
setting buttons.
• Each time one of the two buttons is press-
ed again the DESIRED temperature is ad-
justed by 1°C. The DESIRED temperature
must be reached within 24 hours.
If neither button is pressed, the temperature
indicator automatically switches back after
a short period (approx. 5 sec.) to the indica-
tor of the ACTUAL temperature.
DESIRED temperature means:
The temperature that has been selected for
inside the fridge. The DESIRED temperature
is indicated by flashing numbers.
ACTUAL temperature means:
The temperature indicator shows the cur-
rent temperature inside the fridge. The AC-
TUAL temperature is indicated with illumina-
ted numbers.
Temperature indicator
The temperature indicator shows several in-
formation:
• During normal operation, the temperature
currently present in the fridge (ACTUAL
temperature) is displayed.
• When the temperature is being adjusted
a flashing display indicates the fridge tem-
perature currently set (DESIRED tempera-
ture).
are recyclable.