Control Panel - Kuppersbusch IKE458-5-4T Notice D'utilisation

out by a qualified electrician or compe-
tent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not

Control panel

1 2 3 4
1. Pilot light
2. ON/OFF switch
3. Temperature regulator (warmest)
4. Temperature indicator
5. Temperature regulator (coldest)
6. Alarm light
7. Alarm reset switch
8. Fast Freezing light
9. Fast Freezing switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/
OFF switch until the Pilot light and the Tem-
perature indicator switched off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators ,
the current temperature setting flashes on
the Temperature indicator. It is possible to
modify the setting temperature only with
flashed indicator. To set a warmer tempera-
ture, press warmest Temperature regula-
tor . To set a colder temperature, press cold-
est Temperature regulator. The Tempera-
ture indicator displays the newly selected
temperature for a few seconds and then
Freezer Control panel
5 6 7 8 9
be discarded together with the urban re-
fuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
shows again the inside compartment tem-
perature.
The newly selected-temperature must be
reached after 24 hours.
Caution! During the stability period by
the first starting the temperature
displayed can not correspond to the
setting temperature.
Temperature indicator
During normal functioning the Temperature
indicator shows the temperature inside the
freezer.
Important! Difference between the
temperature displayed and temperature
setting is normal. Especially when:
• a new setting has recently been selected.
• the door has been left open for a long time.
• warm food has been placed in the com-
partment.
Excessive temperature alarm
In the event of an abnormal temperature
rise inside the freezer (e.g. power cut) Alarm
light will start to flash and a buzzer will sound.
After the temperature has returned to nor-
mal, the Alarm light will continue to flash, al-
though the buzzer has stopped.
When the Alarm reset switch is pressed,
the warmest temperature reached in the
are recyclable.
21