Kenwood SW-508 Mode D'emploi page 6

Connecting to Amp's Subwoofer Preout jack
Using the supplied pin-plug cord, connect the Subwoofer
Preout jack on your amplifier or receiver to the LINE INPUT
jack on the subwoofer.
Note:
Do not use LINE INPUT jack and SPEAKER INPUT terminals at
the same time.
Connecting to Amp's Speaker output terminals
Connect the SPEAKER INPUT terminals on the subwoofer
to the speaker output terminals on your amplifier or
receiver. Connect the SPEAKER OUTPUT terminals on the
subwoofer to your front speakers.
SPEAKERS (6-8Ω)
Speaker
terminals
Amplifier or Receiver
Notes:
1. Speaker cord for the connection
between the amplifier or receiver
and the subwoofer is not included.
Please purchase this cord sepa-
rately.
2. If your amplifier or receiver has
two sets of speaker output termi-
nals, you can connect the front
speakers directly to the second set
of terminals (rather than connect-
ing them to the SPEAKER OUT-
PUT terminals on the subwoofer).
3. Do not use LINE INPUT jack and
SPEAKER INPUT terminals at the
same time.
6
EN
Amplifier or Receiver
SUBWOOFER
PRE OUT
SUB
WOOFER
Speaker cord (Commercially available parts)
Front speaker (R)
CAUTION
÷ The front speakers connected with the Subwoofer should have the impedance
specified by the amplifier or receiver in use.
÷ When connecting the Subwoofer to the amplifier or receiver, be sure to always
connect the "+" terminals to "+" terminals and the "–" terminals to "–" terminals.
If terminals are connected incorrectly, the amplifier or receiver may be damaged.
CAUTION
Set the POWER switches of the amplifier or receiver
and Subwoofer to OFF. If they are connected with the
POWER switch(es) left ON, one or both components
may be damaged.
LINE INPUT
Pin-plug cord
CAUTION
Set the POWER switches of the amplifier or receiver
and Subwoofer to OFF. If they are connected with the
POWER switch(es) left ON, one or both components
may be damaged.
SPEAKER INPUT
R L
AUTO SHUT OFF
ON OFF
R L
LINE INPUT
SPEAKER OUTPUT
Speaker cord
(Commercially available
parts)
Front speaker (L)
SPEAKER INPUT
R L
AUTO SHUT OFF
ON OFF
R L
LINE INPUT
SPEAKER OUTPUT
Twist the wire.