VINCENT PHO-700 Manuel D'utilisation page 20

3
5
3. POWER: mains switch
This is the main power switch for turning on
and off the PHO-700. Always switch on the
PHO-700 before you switch on the ampli-
fier/preamplifier!
4. DC OUT: Power supply output
to PHO 700
Make a connection to the power supply input
(9) of the PHO-700 using the supplied DIN
cable.
5. AC/FUSE: power connector
and fuse holder
To establish the power supply, connect the
plugs of the power cable to the device and to
a wall power outlet. The small plastic housing
beneath the mains socket holds the fuse. Refer
to the Safety Guidelines.
6. LAMP: Dimmer for the tube illumination
The setting of this switch affects the brightness of
the illumination of the tube display window (2).
7. OUT: signal output to the amplifier
A pair of RCA input sockets of your system's
audio amplifier must be connected with these
output sockets.
Vincent
20
REAR VIEW
4 11
8. GND: Ground clamp for the
record player
In addition to the stereo signal connection
cable most record players are equipped with
a grounding cable that can be recognized by
the cable lug at the end of the cable. This lug
has to be fitted to the clamp "GND".
9. DC IN: power supply input of
the PHO-700
Make a connection to the power supply output
(5) of the PHO-700ps using the supplied DIN
cable.
10. MC/MM: pickup type switch
At this switch the type of record player pickup
system has to be selected to adapt the phono pre-
amplifier PHO-700 to that system. See section
"Setting the type of pickup system".
11. IN: signal input (MC/MM) from
the record player
The audio output (or as well an attached
audio cable) of the record player must be con-
nected to these input sockets.
8 7
10
6
9