DOMUS LINE Vega Manuel D'installation page 6

INSTALLATION MANUAL
The output cable of VEGA SDM can handle a load of max. 72W
@ 24VDC included the absorption of the device figure 4.
OPERATION VEGA:
VEGA is a switch-free spotlight, then it must be turned on via a
remote switch that can be placed on the VEGA SDM (wired in
the MASTER version) as shown in figure 4 or it can be assigned
to a separate switch connected to the primary of the converter
as shown in figure 3, or to a remote socket where to connect the
converter.
ATTENTION: VEGA SDM must be connected directly to the
electronic feeder and it must not be connected after other
electronic switches.
The sensor must not be installed near electromagnetic sources,
heat sources or exposed to direct sunlight.
WARNING:
The Led MODULE, the power supply cable and the electronic
switch, are not replaceable, therefore in case of damage the
device must be entirely substituted.
EN
WARRANTY:
The warranty on the device is valid only if powered by a power
supply provided by DOMUS Line. The warranty's general terms
and conditions for this device are available at
www.domusline.com
CAUTION
Use only with 24 Vdc Class 2 power unit.