Télécharger Imprimer la page

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATION MANUAL
WARNING:
Safety is guaranteed if these instructions are followed and
therefore they must be kept. Installation may require the
involvement of qualified personnel. Before proceeding with
installation of the device ensure that the environmental
conditions are in compliance with and suitable for the product
characteristics. Before any operation on the device disconnect
mains power.

CONFIGURATION:

Instructions for installation and use contained in this manual are
valid for several configurations of the VEGA device, for which
there are differences. VEGA SDM (touch sensor) model refers to
the configuration of the device that includes a dimmable
electronic switch.
VEGA model refers to the configuration of the device that does
not incorporate any switch or sensor.
INSTALLATION:
VEGA and VEGA SDM unit are recommended for installation
under wall units or shelves. Installation can be done with the
power cable to the light positioned axially or radially with regard
to the fitting plan.
EN
- Fix device (A) using the screws (B) supplied as indicated in
Fig. 1,2.
- Connect the spotlights to the adaptor and using the extensions
provided in the pack (D) following the wiring diagram:
- SLAVE: (fig.3) (without switch)
- SDM: (fig.4) (TOUCH SENSOR master)
- Connect the feeder plug (E) to an AC outlet 230V 50/60Hz.
- Connect the device power cable to an appropriate (check plate
data printed on the product label) safe power supply with
stabilized voltage (not included) with power 10% higher than the
total load.
- If more than one device must be connected to the power
supply ensure that the total sum of the power absorbed by the
devices (check the plate data shown on the product label) does
not exceed the maximum power permitted by the Converter.
OPERATION VEGA SDM:
Switching on and off takes place by simply approaching the
sensitive IR switch (C), keeping a steady hand, faced with the
same, you can adjust the intensity of light.
A short flash of the light indicates the achievement of maximum
brightness.
The luminosity level obtained will be saved until the next
adjustment.

Publicité

loading

Ce manuel est également adapté pour:

Vega sdm