Pioneer SX-315 Mode D'emploi page 18

04 Surround sound setup
Setting the channel levels while playing a
source
The following way of setting the channel levels is best
done while playing a multichannel source, such as a
DVD. See also the following chapter, Listening to your
system on page 19 for more on playing sources.
1 Press CH LEVEL on the remote or CHANNEL LEVEL
on the front panel to select a speaker to adjust.
Each press changes the selected speaker:
• L – Left front speaker
• C – Center speaker
• R – Right front speaker
• RS – Right surround speaker
• LS – Left surround speaker
• SW – Subwoofer
On the right side of the display you can see the current
channel level setting. Initially these are all set at zero.
2 Use the
change the setting for the displayed speaker.
You can adjust each speaker from –10 (quieter) to +10
(louder).
• You can also use the front panel < and > buttons,
although it's usually best to make this setting from
your listening position using the remote.
3 When you're done, press ENTER to exit.
If no button is pressed for ten seconds, channel setting is
automatically exited.
18
En
CH LEVEL
ENTER
(cursor left/right) buttons to