Safety Regulations; Layout And Items Supplied - EINHELL TC-SY 600 S Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1-4)
Fig. 1a: TC-SY 600 S
Fig. 1b: TC-SY 700 S
1 Air cap retaining ring
2 Air cap
3 Nozzle
4 Locking lever
5 Trigger
6 Max. paint volume control
7 Pistol mounting
8 Viscosity cup
9 Transport handle
10 Material tube connection
11 Material tube
12 Container
13 Fluid needle (plastic)
14 Trigger unit
15. Handle
16 Filter cap
17 Shoulder strap
18 On/Off switch
19 Air hose
20 Cradle*
Anl_TC_SY_600_700_SPK1.indb 21 Anl_TC_SY_600_700_SPK1.indb 21
GB
A Cleaning needle
B Adapter for fl uid needle
*only included with TC-SY 700 S
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Container
•
Cleaning brush (not shown)
•
Cleaning needle
•
Viscosity cup
•
Cap
•
2.5 mm nozzle, mounted on the pistol
(colour: black)
•
Replacement nozzle, 3 mm (colour: grey)
•
Adapter for fluid needle
•
Shoulder strap
•
Cradle*
•
Original operating instructions
•
Safety information
*only included with TC-SY 700 S
- 21 -
21.09.2016 11:26:42 21.09.2016 11:26:42