Table des Matières
Publicité
F11-3
48
English
11. Maintenance of Saw Chain and Guide Bar
■ GUIDE BAR
• Reverse the bar occasionally to prevent partial
wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(F11-3)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
WARNING
This saw is equipped with one of the following low
kickback bar/chain combinations:
Bar Size
18" (45cm)
180RNDD176
20" (50cm)
200RNDD176
24" (60cm)
240RNDD176
For replacement use only above bars and chains or
the following:
OREGON BAR
18, 20, or 24 inch POWER MATCH®
(pitch: 3/8") Mount code #D176.
GB BAR
18, 20, or 24 inch PRO SPROCKET NOSE
(pitch: 3/8") Mount code #D176.
PRO TOP BAR (pitch: 3/8") Mount code E & EX
OREGON CHAIN
72V
RedMax Part Number
Guide Bar
Saw Chain
72V66X
72V70X
72V81X
Publicité
Table des Matières
