LaserLiner PrecisionPlane-Laser 3G Pro Mode D'emploi page 20

Adjusting both axes
X axis: The slope function LED (18) flashes rapidly.
Y axis: The slope function LED (18) flashes slowly.
7
Adjust vertical slope, to a max. of 2° (X, Y axis)
8
Slope function > 2°
Steeper slopes can be set using the angle plate, which is available as an
optional extra (product ref. 080.75). To this end you need to use a crank
tripod, such as the 300 cm crank tripod P 300 cm, product ref. 080.39.
Refer to the illustrations below.
TIP: Set the angle plate to the zero position and allow the device to align
itself automatically. Then switch off the automatic sensor with button 14
(slope function ON). Finally, incline the device to the angle you require.
Slope adjustment > 2°
20
EN
3 sec.
3 sec.
1 sec.
3 sec.