Publicité
Les langues disponibles
Les langues disponibles
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger of
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
This product is intended for domestic lawn mowing.
It is not designed for commercial use.
1. Switch lever
2. Handle top
3. Switch case
4. Safety button
5. Wing nuts
6. Handle bottom
7. Grass bag
8. Deflector guard
9. Front cover
10. Wheels
11. Cable holder
ASSEMBLY «
The lawn mower is delivered unassembled. The
complete push bar must be assembled before
using the lawn mower. Follow the operating
instructions step-by-step and use the pictures
provided as a visual guide to easily assemble the
machine.
> Preparation
§ Put the cable hook on upper handle.
§ Connect upper and lower handles with supplied
screws and knobs.
§ Insert the handles into the mower body.
§ Fit each wheels over the axles, secure in place
with the "R" pins and press the wheel
covers into place.
§ Fix the cable holders.
§ Grasse collection box assembly. Assemble two
halves and fix them together.
§ Lift the flap and place the grass box over the lugs.
>
The grass catcher
To fit: Raise the rear cover and hitch the grass
catcher on rear of mower.
To remove: grasp and lift rear cover, remove
grass catcher.
suffocation!
Fig A »
SETTING THE CUTTING HEIGHTS
«
Fig C »
Adjust the cutting height only
when the engine is switched
off and the power cable has
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt
and/or damaged blades. To carry out this check,
first switch off the motor and pull out the power plug.
To obtain the desired cutting height, the front and
rear axles are repositioned on the underside
of the mower housing.
Disconnect the mower from
the power supply and ensure
the blade has stopped
coasting before adjusting the
> To adjust the front wheel cutting height
position
§ Turn the mower upside down.
§ Pull the wheel axle towards the front of the
mower.
§ Locate the wheel axle into the desired cutting
height adjustment position.
> To adjust the rear wheel cutting height
position
§ Turn the mower on its side.
§ Pull the rear wheel axle towards the mower's
catcher flap.
§ Locate the wheel axle into the desire cutting
height adjustment position.
Note: Make sure that both
rear right and left wheel are
cutting height adjustment
> 5 Cutting height positions
25mm ~ 75 mm
§ 25 mm (lowest cutting height position)
~
§ 62 mm (highest cutting height position)
Important!
been disconnected.
Warning!
height.
located in the same
position.
36
Publicité
